Error codes, fixes and maintenance for home hot tubs

Hot Tub Light Leaking: Resealing Spa Lights

Leaks & Plumbing · Last reviewed 2026-11-21

Quick answer

Spa lights, including the small LED point lights set into the shell, are sealed by gaskets and sealant around the housing. Over time the sealant cracks and water seeps behind the shell, often showing up as water inside the cabinet with no obvious source. The fix is to drain below the light, clean off the old sealant and reseal or replace the gasket.

Most likely causes

  1. Cracked sealant. Sun, heat and chemicals harden it over time.
  2. Worn gasket or nut. Behind the shell.
  3. Cracked lens or housing. Needs replacing.

Step-by-step troubleshooting

  1. Watch whether the water level stops at light height.
  2. Dye test around each light with the pumps off.
  3. Turn off power and drain the water below the light.
  4. From inside the tub, remove old cracked sealant around the light and clean and dry the area thoroughly.
  5. From behind (if reachable), check the housing nut and gasket.
  6. Apply a sealant rated for underwater use and compatible with acrylic and spa chemicals, following the cure time before refilling.
  7. Replace the light housing if cracked.

Parts for this repair

Always match the model and part number on your appliance's data plate or the old part before ordering.

Links go to eBay search results. We may earn a commission.

When to call a technician

If the light housing is buried in foam or the leak is behind the shell, a technician can access it with less damage.