Error codes, fixes and maintenance for home hot tubs

How to Test a Hot Tub Heater Element

Hot Tub Heater Problems · Last reviewed 2026-11-21

Quick answer

With the power off at the breaker, disconnect the heater element terminals and measure resistance across them with a multimeter. A working 240-volt element of around 4 to 5.5 kW typically reads roughly 10 to 15 ohms; an open circuit (OL) means it's burned out. Also check from each terminal to the heater's metal housing: any reading other than open means a short to ground, which trips the GFCI.

How to test it

  1. Turn off power at the breaker and GFCI disconnect, and confirm with a tester.
  2. Open the control box and find the heater terminals.
  3. Photograph the connections, then disconnect them.
  4. Set the multimeter to ohms. Measure across the two element terminals.
  5. Compare with the expected value for your element's wattage and voltage. Roughly: resistance = volts squared divided by watts.
  6. Measure from each terminal to the heater tube or ground lug. It should read open circuit.
  7. Reconnect everything exactly as it was.
ElementApproximate resistance
5.5 kW at 240VAbout 10.5 ohms
4 kW at 240VAbout 14.4 ohms
1 kW at 120VAbout 14.4 ohms

Parts for this repair

Always match the model and part number on your appliance's data plate or the old part before ordering.

Links go to eBay search results. We may earn a commission.

When to call a technician

If you're not confident working inside the control box, a technician can test the heater in minutes.