Hot Tub Not Heating: Step-by-Step Troubleshooting
Quick answer
Start with settings: make sure the set temperature is above the water temperature and the tub isn't in economy, sleep or rest mode. Then check flow, since dirty filters, low water and air locks stop the heater from running. If there's good flow and no error code, the element, a relay or the board may have failed.
Most likely causes
- Mode or set temperature. Economy, sleep and rest modes only heat during filter cycles.
- Dirty filters or low flow. Often with a FLO or similar code. See Hot Tub FLO Error: What It Means and How to Fix It.
- Air lock after refilling. See How to Fix a Hot Tub Air Lock.
- Tripped high limit. See Hot Tub OH, OHH or OHS Overheat Error.
- Burned-out heater element. See How to Test a Hot Tub Heater Element.
- Failed heater relay or board. The board stops sending power to the heater.
- Heat loss. Waterlogged cover or open cover. See Hot Tub Loses Heat Overnight.
- Circulation pump failure. On tubs that use one for heating.
- 120-volt limits. Plug-and-play tubs can't run the heater and high-speed jets at the same time.
Step-by-step troubleshooting
- Check the display for error codes and the heat indicator light.
- Raise the set temperature a few degrees above the current water temperature.
- Switch from economy or sleep mode to standard or ready mode.
- Clean the filters and top up the water.
- Bleed air from the pump and heater.
- Turn off the jets on 120-volt tubs and let it heat.
- If the heat light is on but the water doesn't warm, turn off power and test the heater element.
Parts for this repair
Always match the model and part number on your appliance's data plate or the old part before ordering.
- Hot tub heater elementMatch your heater assembly.
- Balboa heater assembly
- Gecko heater
- Floating thermometer
Links go to eBay search results. We may earn a commission.
When to call a technician
Testing heater voltage and relays inside the control box involves live 240-volt circuits. Leave that to a technician.
Common questions
How fast should a hot tub heat?
Many 240-volt tubs heat a few degrees Fahrenheit per hour with the cover on. 120-volt tubs are much slower, often around 1°F per hour or less.
Why does it heat at night but not during the day?
Some tubs are set to heat only during filter cycles in economy mode, or use time-of-use settings.