How to Fix a Hot Tub Air Lock
Quick answer
An air lock happens when air is trapped in the pump after draining and refilling, so the pump hums or runs without moving water. Fix it by loosening the union nut on the discharge side of the pump (top) until water seeps out, then retightening. Running the jets on low and high alternately, and filling through the filter housing, also help.
How to bleed the air
- Turn off the pump.
- Fill the tub through the filter housing (with a hose in the filter compartment) next time. This pushes water through the plumbing first.
- Open the equipment bay and loosen the union on top of the pump slightly until air hisses and water seeps out. Retighten by hand.
- Run the pump on low for a few seconds, then high, switching a few times.
- If the circulation pump has a bleed screw, open it until water flows.
- Repeat until the jets run steadily.
Parts for this repair
Always match the model and part number on your appliance's data plate or the old part before ordering.
Links go to eBay search results. We may earn a commission.
Common questions
How long can I let the pump run air-locked?
Not long. A pump running without water can damage the shaft seal within minutes. Stop it if it isn't moving water.