Hot Tub Pump Humming but Not Running
Quick answer
A pump that hums but doesn't spin is getting power but can't turn. The usual causes are seized motor bearings (common after sitting), debris jamming the impeller, or a failed start capacitor on motors that have one. Turn it off right away, because a humming motor overheats quickly.
Most likely causes
- Seized bearings. Often after the tub has been off.
- Jammed impeller. Debris got past the filter.
- Failed capacitor. On capacitor-start motors.
- Low voltage. Undersized wiring or a failing supply.
Step-by-step troubleshooting
- Turn off power.
- Try turning the motor shaft by hand from the back of the motor, if accessible. If it frees up, the motor may run, but bearings are likely worn.
- Close valves, remove the wet end cover and check the impeller for debris.
- If the motor has a capacitor, have it tested or replaced.
- Replace the motor if the bearings are seized or noisy.
Parts for this repair
Always match the model and part number on your appliance's data plate or the old part before ordering.
- Hot tub pump motor
- Pump motor capacitorMatch µF and voltage.
- Pump bearing kit
Links go to eBay search results. We may earn a commission.