Error codes, fixes and maintenance for home hot tubs

Hot Tub Pump Not Working

Pumps, Jets & Air Locks · Last reviewed 2026-11-21

Quick answer

If a hot tub pump won't run at all, check for an error code, then listen at the pump when you press the jet button. Silence points to power, a relay or the panel. Humming without spinning points to a seized motor, a failed start capacitor or debris jamming the impeller. Running without moving water points to an air lock or a broken impeller.

Most likely causes

  1. Air lock. Pump runs but no water moves. See How to Fix a Hot Tub Air Lock.
  2. Seized bearings or impeller. Hums without spinning. See Hot Tub Pump Humming but Not Running.
  3. Failed relay or board output. Silence when the button is pressed.
  4. Tripped thermal overload. Motor shuts off when hot, restarts when cool.
  5. Loose or burned wiring. At the pump or control box.
  6. Failed capacitor. On some motors.

Step-by-step troubleshooting

  1. Note any error code.
  2. Press the jet button and listen at the pump.
  3. If it hums, turn off power immediately to avoid burning the motor.
  4. If it runs but moves no water, bleed the air.
  5. If silent, have the relay and voltage checked at the pump.
  6. With power off, try turning the motor shaft from the back (some motors have a slot). If it won't turn, the bearings are seized.

Parts for this repair

Always match the model and part number on your appliance's data plate or the old part before ordering.

Links go to eBay search results. We may earn a commission.

When to call a technician

Testing pump voltage and relays involves live 240-volt circuits. A technician can tell quickly whether it's the pump or the board.