Error codes, fixes and maintenance for home hot tubs

Hot Tub Pump Leaking

Pumps, Jets & Air Locks · Last reviewed 2026-11-21

Quick answer

Leaks at the pump usually come from the shaft seal between the motor and wet end (water drips from the gap or runs down the motor), the wet end's O-ring, a loose or cracked union, or a drain plug. A leaking shaft seal should be fixed soon, because water reaching the motor bearings ruins them.

Most likely causes

  1. Shaft seal. Drips from between the wet end and motor, or rust under the motor.
  2. Wet end housing O-ring. Leaks around the housing seam.
  3. Unions. Loose nuts or worn O-rings on the pipe connections.
  4. Drain plug. Missing O-ring.
  5. Cracked housing. From freezing.

Step-by-step troubleshooting

  1. Dry the area and run the pump, watching where water appears.
  2. Hand-tighten unions and replace their O-rings if needed.
  3. For shaft seal leaks, replace the seal (requires removing the wet end and impeller), or replace the wet end.
  4. Replace the motor if bearings are rusted or noisy.

Parts for this repair

Always match the model and part number on your appliance's data plate or the old part before ordering.

Links go to eBay search results. We may earn a commission.