Hot Tub OH, OHH or OHS Overheat Error
Quick answer
OH-type codes mean the water or the heater got too hot, and the control shut things down for safety. Don't use the tub until the water cools to a normal temperature. Common causes are hot summer weather combined with long filter cycles, poor flow through the heater, a stuck heater relay, or a faulty sensor.
Most likely causes
- Hot weather and long filtration. In summer, pump heat plus sun can push water above the set point, especially with long filter cycles.
- Low flow through the heater. Clogged filters or an air lock let the heater overheat locally. Often appears with flow codes.
- Heater relay stuck closed. The heater stays on even when it shouldn't. Needs a technician.
- Faulty temperature or high-limit sensor. Reads high when the water isn't.
- Cover left on in direct sun. Traps heat.
Step-by-step troubleshooting
- Stay out of the tub and remove the cover to let the water cool. Adding some cool water helps.
- Clean the filters and check water level and valves.
- In hot weather, shorten filter cycles and lower the set temperature.
- Once the water has cooled, reset the code per your manual, often by pressing a button or cycling power at the breaker.
- Measure the water temperature with a separate thermometer and compare it to the display.
- If the water keeps heating past the set point, turn the tub off at the breaker and call a technician. A stuck relay can overheat the water dangerously.
| Code | Usually means (confirm in your manual) |
|---|---|
| OH / OHS | Spa water temperature too high |
| OHH / HH | Heater too hot, high-limit tripped |
| HL (Gecko) | Heater high limit tripped. See Hot Tub HL, HFL and LF Errors |
Parts for this repair
Always match the model and part number on your appliance's data plate or the old part before ordering.
- Floating spa thermometer
- Hot tub temperature sensorMatch your control system.
- Hot tub high limit sensorMatch your control system.
Links go to eBay search results. We may earn a commission.
When to call a technician
If the water keeps rising above the set temperature, a relay or control board fault is likely. Leave the tub off and call a technician.
Common questions
What temperature is too hot?
Most public health and industry guidance puts the maximum safe soaking temperature at 104°F (40°C). Many controls flag overheating at around 108 to 110°F (42 to 43°C).