Hot Tub FLO Error: What It Means and How to Fix It
Quick answer
FLO (sometimes FL, FL1 or FL2) means the control system isn't sensing enough water flow through the heater, so it won't heat. The most common causes, in order, are dirty filters, low water level, an air lock in the pump after refilling, closed valves, and a faulty or out-of-adjustment pressure or flow switch.
Most likely causes
- Dirty or clogged filters. The number one cause. Remove the filters and see if the code clears.
- Low water level. Water must be above the skimmer opening so the pump doesn't draw air.
- Air lock. Common right after draining and refilling. See How to Fix a Hot Tub Air Lock.
- Closed slice valves or gate valves. Valves on either side of the pump and heater are often closed for service and forgotten.
- Blocked suction or jets. Debris in the suction covers, or several jets closed off.
- Pressure or flow switch. A failed, dirty or out-of-adjustment switch can report no flow even when water is moving.
- Weak pump or circulation pump. A failing pump doesn't push enough water. See Hot Tub Pump Not Working.
Step-by-step troubleshooting
- Check the water level is above the skimmer and filters, and top up if needed.
- Remove the filters and run the pump. If the code clears, clean or replace the filters. See How to Clean a Hot Tub Filter.
- Open all jets and check suction covers for debris.
- Turn off power, open the equipment bay and check that all valves are fully open.
- Bleed air from the pump: loosen the union on top of the pump (or the bleed screw) slightly until water seeps, then retighten. See How to Fix a Hot Tub Air Lock.
- Restore power and watch whether the pump runs strongly.
- If the code persists with good flow, the pressure or flow switch may be faulty or need adjustment. Some systems use a pressure switch on the heater with an adjustment screw; others use a flow switch. Follow your control's manual or call a technician.
| Code | Usually means (confirm in your manual) |
|---|---|
| FLO | No or low flow detected; heater disabled |
| FL1 / FL2 | Variants on some Balboa systems, for example switch stuck closed or open |
| FLC | On some Gecko systems: flow switch reads closed when it shouldn't |
| LF | On some Balboa systems: persistent low flow after repeated flow warnings |
Parts for this repair
Always match the model and part number on your appliance's data plate or the old part before ordering.
- Hot tub filterMatch the size or part number printed on your filter.
- Hot tub pressure switchMatch the part number on your current switch.
- Hot tub flow switchMatch your control system.
- Filter cleaning wand
Links go to eBay search results. We may earn a commission.
When to call a technician
If you've cleaned filters, checked water level and valves, and bled the air, but FLO keeps returning, a technician can test the pump's flow, the switch and the control board.
Common questions
Can I bypass the pressure switch?
No. The switch protects the heater from running dry and overheating. Bypassing it can burn out the heater or cause a fire.
Why did FLO appear right after I refilled the tub?
Almost always an air lock. Bleed the air from the pump and run the jets on high with the filters out for a few minutes.