Hot Tub dr or dry Error: Dry Heater Detected
Quick answer
On Balboa systems, dr usually means the control thinks there's not enough water in the heater and has paused heating. If it happens repeatedly, the code changes to dry and the heater locks out until you reset power. The cause is almost always low water, an air lock or poor flow.
Most likely causes
- Low water level. Below the skimmer.
- Air lock in the heater or pump. After refilling.
- Clogged filters. Restrict flow.
- Closed valves. Flow can't reach the heater.
Step-by-step troubleshooting
- Top up the water.
- Clean the filters, or run briefly without them to test.
- Bleed air from the pump. See How to Fix a Hot Tub Air Lock.
- Open all valves.
- Reset by turning the power off at the breaker for 30 seconds or so, then back on.
Parts for this repair
Always match the model and part number on your appliance's data plate or the old part before ordering.
Links go to eBay search results. We may earn a commission.
When to call a technician
If dr returns with good water level and flow, have the pressure switch and sensors tested.