Hot Tub Pr Code: Priming Mode on Startup
Quick answer
Pr on a Balboa panel at startup isn't an error. It's priming mode, which lasts a few minutes after the tub powers up so you can run the pumps and push air out of the plumbing. Press the jet buttons to run each pump on low and high until water flows steadily from the jets. The tub then leaves priming mode and starts normal operation.
How to prime
- Make sure the tub is filled above the skimmer.
- When Pr shows, press each jet button to run the pumps. Switch between low and high speed.
- Watch the jets for steady water flow without sputtering.
- If a pump hums without moving water, bleed the air. See How to Fix a Hot Tub Air Lock.
- Let the tub exit priming mode on its own or follow the manual.
Parts for this repair
Always match the model and part number on your appliance's data plate or the old part before ordering.
Links go to eBay search results. We may earn a commission.
Common questions
How long does priming mode last?
Usually a few minutes, then the tub starts normal operation.